Adapters

Teflon® PTFE adapter with Viton® O-ring on the body, screw cap and hose connection.

• Not autoclavable

TEFLON® is a registered trademark of The Chemours Company FC LLC and used under license by Bel-Art Products, Inc.

 

These PYREX® thermometer adapters have a ground joint at one end while the other end is tooled to accommodate a thermometer. The adapter comes with a rubber thermometer holder.

 

These PYREX® reducing adapters have a Standard Taper outer joint at the top and a smaller Standard Taper inner joint at the bottom.

 

This PYREX® angle connecting adapter has a sidearm at an approximately 120° angle from the lower joint. The lower end is equipped with an inner 24/40 Standard Taper joint, and the upper end and sidearm with an outer 24/40 Standard Taper joint. This tube is also a replacement part for Corning® organic...

These PYREX® 105° angle vacuum connecting adapters have a tubulation of 10mm O.D. for attaching to a vacuum pump and inner and outer 14/20 Standard Taper joints. Includes a drip-tip on the inner tube. These tubes are also replacement parts for organic chemistry kits No. 6949K.

...

The arms are approximately 105° apart. The upper end is equipped with an outer ST joint. The lower end is cut off at an angle and is used as a receiver adapter. Tube O.D. is 12mm.

 

The arms on these PYREX® tube adapters are approximately 105° apart. One end is equipped with an outer 24/40 Standard Taper joint and the other end has an inner 24/40 Standard Taper joint. Used as a receiver adapter.

 

With outer ST joint at the top and an innersealed through driptip joint at the bottom. Bent at a 105° angle. The serrated sidearm is 10mm O.D. Driptip at the bottom extends about 20mm below the lower end of the joint.